EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Fuchs

FUCHS TITAN GT1 FLEX 23 5W-30

FUCHS TITAN GT1 FLEX 23 5W-30 is a 5W-30 C3 engine oil (ACEA C2, C3 · API SN). According to the manufacturer's data sheet it has a viscosity of 71.8 mm²/s at 40 °C, 12 mm²/s at 100 °C, a viscosity index of 164, a pour point of −42 °C and sulphated ash of 0.7 %.

Data sheet ↗ Data verified: 8 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 5W-30 C3 i
Viscosity 40 °C71.8 mm²/s70 mm²/s
Viscosity 100 °C12 mm²/s12 mm²/s
Viscosity index164 168
TBNnot stated
CCS −30 °Cnot stated
Pour point−42 °C−42 °C
Flash point224 °C230 °C
Density0.853 g/cm³0.851 g/cm³
HTHS 150 °Cnot statedNot stated by the manufacturer. ACEA C3 requires at least 3.5 mPa·s.
Sulphated ash0.7 %0.795 %

All 5W-30 C3 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Specification
ACEA C2, C3 · API SN
Oils by specification

Similar oils

Oils in the 5W-30 C3 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 5W-30 C3 class.

FUCHS TITAN GT1 FLEX 23 5W-30 is a motor oil from Fuchs, viscosity grade 5W-30. In the database we compare it with 120 other oils in the 5W-30 C3 class.

The oil meets ACEA C2, ACEA C3, API SN, BMW LL-04 and more (10 in total). ACEA C2 is a low-ash oil with reduced HTHS (from 2.9 mPa·s) for DPF engines where the carmaker wants lower friction. ACEA C3 means a mid-SAPS oil (max 0.8 % ash) with HTHS of at least 3.5 mPa·s for petrol and diesel engines with a particulate filter. API SN is an older American specification for petrol engines. MB 229.51 is the Mercedes-Benz approval for engines with a DPF. GM dexos2 is the GM (Opel) approval for engines with a DPF.

Viscosity at 100 °C is 12 mm²/s, near the upper end of the 9.3–12.5 mm²/s range for the summer grade 30. Within its class the oil is on the thick side, with more reserve at high temperatures.

Average values: pour point −42 °C is close to the class middle (median −42).

Weaker values: viscosity index 164 is in the weaker half of the class (median 168); flash point 224 °C is in the weaker half of the class (median 230).

Limit values: sulphated ash of 0.7 % is suitable for engines with a DPF.

Based on its values it suits engines with a DPF and higher loads, towing or high-mileage engines. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state HTHS, TBN and Noack volatility, so we cannot compare it on these parameters.