PennGrade 1 High Performance 20W-50
PennGrade 1 High Performance 20W-50 is a 20W-50 engine oil (20W-50). According to the manufacturer's data sheet it has a viscosity of 159 mm²/s at 40 °C, 20 mm²/s at 100 °C, a viscosity index of 140, HTHS of 6.2 mPa·s, a TBN of 10.6 mg KOH/g and sulphated ash of 1.2 %.
Data sheet ↗ Data verified: 19 Nov 2026
Parameters from the data sheet
| Parameter | Value | Class median 20W-50 i |
|---|---|---|
| Viscosity 40 °C | 159 mm²/s | 159 mm²/s |
| Viscosity 100 °C | 20 mm²/s | 19.8 mm²/s |
| Viscosity index | 140 | 140 |
| TBN | 10.6 mg KOH/g | 8.15 mg KOH/g |
| CCS −15 °C | not stated | |
| Pour point | −27 °CThe manufacturer gives only a limit, "at most −27", not a measured value. | −35 °C |
| Flash point | 216 °C | 224 °C |
| Density | 0.88 g/cm³ | 0.88 g/cm³ |
| HTHS 150 °C | 6.2 mPa·s | 5.4 mPa·s |
| Sulphated ash | 1.2 % | 1 % |
All 20W-50 oils → See the class table for a detailed comparison with other oils.
Similar oils
Oils in the 20W-50 class with the closest parameters and the same specification.
- Red Line 20W-50ACEA A3/B3 · API SN
- AMSOIL OE 20W-50API SN PLUS
- Valvoline Advanced Full Synthetic 20W-50ACEA A3/B3, A3/B4 · API SP
- Royal Purple HPS 20W-50
- Valvoline VR1 Racing 20W-50
- Pennzoil 20W-50API SN
Oil analysis
We wrote this text by comparing the data-sheet values with the other oils in the 20W-50 class.
PennGrade 1 High Performance 20W-50 is a motor oil from PennGrade, viscosity grade 20W-50. In the database we compare it with 9 other oils in the 20W-50 class.
The data sheet lists no specifications or carmaker approvals, so it only suits engines whose manual does not require a specific approval.
Viscosity at 100 °C is 20 mm²/s, in the middle of the 16.3–21.9 mm²/s range for the summer grade 50.
Strengths: HTHS 6.2 mPa·s is among the best 10 % in the class (median 5.4); TBN 10.6 mg KOH/g is among the best 10 % in the class (median 8.2).
Average values: viscosity index 140 is close to the class middle (median 140).
Weaker values: flash point 216 °C is in the weaker half of the class (median 227).
Limit values: HTHS 6.2 mPa·s meets the 3.7 mPa·s minimum required for this class; sulphated ash of 1.2 % is higher; the oil is not intended for engines with a DPF.
Based on its values it suits engines without a DPF. The specification or approval in your vehicle manual always has the final word.
The data sheet does not state Noack volatility, so we cannot compare it on this parameter.