EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Castrol

Castrol GTX High Mileage 5W-30

Castrol GTX High Mileage 5W-30 is a 5W-30 engine oil (API SQ · ILSAC GF-7). According to the manufacturer's data sheet it has a viscosity of 61 mm²/s at 40 °C, 10.1 mm²/s at 100 °C, a viscosity index of 155, a pour point of −42 °C and sulphated ash of 0.83 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 5W-30 i
Viscosity 40 °C61 mm²/s61.2 mm²/s
Viscosity 100 °C10.1 mm²/s10.7 mm²/s
Viscosity index155 166
TBNnot stated
CCS −30 °C5460 mPa·s4965 mPa·s
Pour point−42 °C−42 °C
Flash point205 °CMeasured in a closed cup (PMCC), so lower than the COC values in the other rows.230 °C
Density0.854 g/cm³0.851 g/cm³
HTHS 150 °Cnot stated
Sulphated ash0.83 %0.87 %

All 5W-30 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Specification
API SQ · ILSAC GF-7
Oils by specification

Similar oils

Oils in the 5W-30 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 5W-30 class.

Castrol GTX High Mileage 5W-30 is a motor oil from Castrol, viscosity grade 5W-30. In the database we compare it with 44 other oils in the 5W-30 class.

The oil meets API SQ, ILSAC GF-7, Ford WSS-M2C961-A1, Chrysler MS-6395. API SQ is the latest American specification for petrol engines, introduced in 2025. Chrysler MS-6395 is the Stellantis approval for Jeep, Dodge, RAM and Chrysler petrol engines. Ford WSS-M2C… approvals apply to specific Ford engines, check them against the owner's manual.

Viscosity at 100 °C is 10.1 mm²/s, near the lower end of the 9.3–12.5 mm²/s range for the summer grade 30. Within its class the oil is on the thin side, which helps fuel economy.

Average values: pour point −42 °C is close to the class middle (median −42).

Weaker values: viscosity index 155 is among the weakest in the class (median 166); CCS 5460 mPa·s is in the weaker half of the class (median 4900).

Limit values: CCS 5460 mPa·s at −30 °C is 83 % of the SAE limit (6600 mPa·s); sulphated ash of 0.83 % is higher; the oil is not intended for engines with a DPF.

Based on its values it suits engines without a DPF and everyday driving where fuel economy matters most. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state HTHS, TBN and Noack volatility, so we cannot compare it on these parameters.