EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · PennGrade

PennGrade 1 High Performance 10W-30

PennGrade 1 High Performance 10W-30 is a 10W-30 engine oil (10W-30). According to the manufacturer's data sheet it has a viscosity of 68.6 mm²/s at 40 °C, 10.8 mm²/s at 100 °C, a viscosity index of 138, HTHS of 3.54 mPa·s, a TBN of 10.6 mg KOH/g and sulphated ash of 1.2 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 10W-30 i
Viscosity 40 °C68.6 mm²/s67.6 mm²/s
Viscosity 100 °C10.8 mm²/s10.9 mm²/s
Viscosity index138 148
TBN10.6 mg KOH/g9.3 mg KOH/g
CCS −25 °C6300 mPa·s5000 mPa·s
Pour point−33 °CThe manufacturer gives only a limit, "at most −33", not a measured value.−39 °C
Flash point204 °C226 °C
Density0.875 g/cm³0.865 g/cm³
HTHS 150 °C3.54 mPa·s3.4 mPa·s
Sulphated ash1.2 %0.995 %

All 10W-30 oils → See the class table for a detailed comparison with other oils.

Similar oils

Oils in the 10W-30 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 10W-30 class.

PennGrade 1 High Performance 10W-30 is a motor oil from PennGrade, viscosity grade 10W-30. In the database we compare it with 23 other oils in the 10W-30 class.

The data sheet lists no specifications or carmaker approvals, so it only suits engines whose manual does not require a specific approval.

Viscosity at 100 °C is 10.8 mm²/s, in the middle of the 9.3–12.5 mm²/s range for the summer grade 30.

Strengths: TBN 10.6 mg KOH/g is among the best 10 % in the class (median 9.3).

Average values: HTHS 3.5 mPa·s is close to the class middle (median 3.4).

Weaker values: viscosity index 138 is among the weakest in the class (median 148); CCS 6300 mPa·s is among the weakest in the class (median 4783); flash point 204 °C is among the weakest in the class (median 227).

Limit values: HTHS 3.5 mPa·s meets the 2.9 mPa·s minimum required for this class; CCS 6300 mPa·s at −25 °C is 90 % of the SAE limit (7000 mPa·s); sulphated ash of 1.2 % is higher; the oil is not intended for engines with a DPF.

Based on its values it suits engines without a DPF. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state Noack volatility, so we cannot compare it on this parameter.