EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · PennGrade

PennGrade 1 High Performance 15W-40

PennGrade 1 High Performance 15W-40 is a 15W-40 engine oil (15W-40). According to the manufacturer's data sheet it has a viscosity of 113 mm²/s at 40 °C, 15.5 mm²/s at 100 °C, a viscosity index of 145, HTHS of 4.52 mPa·s, a TBN of 10.6 mg KOH/g, a pour point of −42 °C and sulphated ash of 1.2 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 15W-40 i
Viscosity 40 °C113 mm²/s114.44 mm²/s
Viscosity 100 °C15.5 mm²/s15.2 mm²/s
Viscosity index145 138
TBN10.6 mg KOH/g10.05 mg KOH/g
CCS −20 °Cnot statedThe manufacturer gives CCS at a different temperature than SAE specifies for this grade, so we do not show it.
Pour point−42 °C−37 °C
Flash point204 °C230 °C
Densitynot stated
HTHS 150 °C4.52 mPa·s4.26 mPa·s
Sulphated ash1.2 %1 %

All 15W-40 oils → See the class table for a detailed comparison with other oils.

Similar oils

Oils in the 15W-40 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 15W-40 class.

PennGrade 1 High Performance 15W-40 is a motor oil from PennGrade, viscosity grade 15W-40. In the database we compare it with 20 other oils in the 15W-40 class.

The data sheet lists no specifications or carmaker approvals, so it only suits engines whose manual does not require a specific approval.

Viscosity at 100 °C is 15.5 mm²/s, near the upper end of the 12.5–16.3 mm²/s range for the summer grade 40. Within its class the oil is on the thick side, with more reserve at high temperatures.

Strengths: viscosity index 145 is in the top quarter of the class (median 138); HTHS 4.5 mPa·s is in the top quarter of the class (median 4.3); TBN 10.6 mg KOH/g is in the top quarter of the class (median 10.1).

Average values: pour point −42 °C is close to the class middle (median −37).

Weaker values: flash point 204 °C is among the weakest in the class (median 232).

Limit values: HTHS 4.5 mPa·s meets the 3.7 mPa·s minimum required for this class; sulphated ash of 1.2 % is higher; the oil is not intended for engines with a DPF.

Based on its values it suits engines without a DPF and higher loads, towing or high-mileage engines. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state Noack volatility, so we cannot compare it on this parameter.