EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · PennGrade

PennGrade 1 High Performance 5W-30

PennGrade 1 High Performance 5W-30 is a 5W-30 engine oil (5W-30). According to the manufacturer's data sheet it has a viscosity of 65.6 mm²/s at 40 °C, 11.1 mm²/s at 100 °C, a viscosity index of 161, HTHS of 3.185 mPa·s, a TBN of 10.6 mg KOH/g, a pour point of −42 °C and sulphated ash of 1.2 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 5W-30 i
Viscosity 40 °C65.6 mm²/s61.2 mm²/s
Viscosity 100 °C11.1 mm²/s10.7 mm²/s
Viscosity index161 166
TBN10.6 mg KOH/g8.6 mg KOH/g
CCS −30 °Cnot statedThe manufacturer gives CCS at a different temperature than SAE specifies for this grade, so we do not show it.
Pour point−42 °C−42 °C
Flash point202 °C230 °C
Density0.858 g/cm³0.851 g/cm³
HTHS 150 °C3.185 mPa·s3.2 mPa·s
Sulphated ash1.2 %0.87 %

All 5W-30 oils → See the class table for a detailed comparison with other oils.

Similar oils

Oils in the 5W-30 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 5W-30 class.

PennGrade 1 High Performance 5W-30 is a motor oil from PennGrade, viscosity grade 5W-30. In the database we compare it with 44 other oils in the 5W-30 class.

The data sheet lists no specifications or carmaker approvals, so it only suits engines whose manual does not require a specific approval.

Viscosity at 100 °C is 11.1 mm²/s, in the middle of the 9.3–12.5 mm²/s range for the summer grade 30.

Strengths: TBN 10.6 mg KOH/g is among the best 10 % in the class (median 8.6).

Average values: pour point −42 °C is close to the class middle (median −42).

Weaker values: viscosity index 161 is in the weaker half of the class (median 166); HTHS 3.2 mPa·s is in the weaker half of the class (median 3.2); flash point 202 °C is among the weakest in the class (median 232).

Limit values: HTHS 3.2 mPa·s meets the 2.9 mPa·s minimum required for this class; sulphated ash of 1.2 % is higher; the oil is not intended for engines with a DPF.

Based on its values it suits engines without a DPF. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state Noack volatility, so we cannot compare it on this parameter.