EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Castrol

Castrol GTX 10W-30

Castrol GTX 10W-30 is a 10W-30 engine oil (API SQ · ILSAC GF-7). According to the manufacturer's data sheet it has a viscosity of 66 mm²/s at 40 °C, 10.1 mm²/s at 100 °C, a viscosity index of 139, a pour point of −33 °C and sulphated ash of 0.75 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 10W-30 i
Viscosity 40 °C66 mm²/s67.6 mm²/s
Viscosity 100 °C10.1 mm²/s10.9 mm²/s
Viscosity index139 148
TBNnot stated
CCS −25 °C5619 mPa·s5000 mPa·s
Pour point−33 °C−39 °C
Flash point204 °CMeasured in a closed cup (PMCC), so lower than the COC values in the other rows.226 °C
Density0.862 g/cm³0.865 g/cm³
HTHS 150 °Cnot stated
Sulphated ash0.75 %0.995 %

All 10W-30 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Specification
API SQ · ILSAC GF-7
Oils by specification

Similar oils

Oils in the 10W-30 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 10W-30 class.

Castrol GTX 10W-30 is a motor oil from Castrol, viscosity grade 10W-30. In the database we compare it with 23 other oils in the 10W-30 class.

The oil meets API SQ, ILSAC GF-7, Chrysler MS-6395. API SQ is the latest American specification for petrol engines, introduced in 2025. Chrysler MS-6395 is the Stellantis approval for Jeep, Dodge, RAM and Chrysler petrol engines.

Viscosity at 100 °C is 10.1 mm²/s, near the lower end of the 9.3–12.5 mm²/s range for the summer grade 30. Within its class the oil is on the thin side, which helps fuel economy.

Average values: CCS 5619 mPa·s is close to the class middle (median 4783).

Weaker values: viscosity index 139 is among the weakest in the class (median 148); pour point −33 °C is among the weakest in the class (median −39).

Limit values: CCS 5619 mPa·s at −25 °C is 80 % of the SAE limit (7000 mPa·s); sulphated ash of 0.75 % is suitable for engines with a DPF.

Based on its values it suits engines with a DPF and everyday driving where fuel economy matters most. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state HTHS, TBN and Noack volatility, so we cannot compare it on these parameters.