EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Performance Plus

Performance Plus Full Synthetic dexos1 Gen3 0W-20

Performance Plus Full Synthetic dexos1 Gen3 0W-20 is a 0W-20 engine oil (API SP · ILSAC GF-6A). According to the manufacturer's data sheet it has a viscosity of 44 mm²/s at 40 °C, 8.2 mm²/s at 100 °C, a viscosity index of 163, a pour point of −42 °C and sulphated ash of 0.8 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 0W-20 i
Viscosity 40 °C44 mm²/s44.145 mm²/s
Viscosity 100 °C8.2 mm²/s8.4 mm²/s
Viscosity index163 169
TBNnot stated
CCS −35 °C5600 mPa·s5670 mPa·s
Pour point−42 °C−42.5 °C
Flash point226 °C225 °C
Density0.845 g/cm³0.845 g/cm³
HTHS 150 °Cnot stated
Sulphated ash0.8 %0.79 %

All 0W-20 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Specification
API SP · ILSAC GF-6A
Oils by specification

Similar oils

Oils in the 0W-20 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 0W-20 class.

Performance Plus Full Synthetic dexos1 Gen3 0W-20 is a motor oil from Performance Plus, viscosity grade 0W-20. In the database we compare it with 31 other oils in the 0W-20 class.

The oil meets API SP, ILSAC GF-6A, GM dexos1 Gen3, Ford WSS-M2C947-B1 and more (5 in total). API SP is the American specification for petrol engines with protection against low-speed pre-ignition (LSPI). ILSAC GF-6A is the US–Japanese specification for fuel-efficient petrol engines with LSPI protection. GM dexos1 is the General Motors licence for petrol engines. Chrysler MS-6395 is the Stellantis approval for Jeep, Dodge, RAM and Chrysler petrol engines.

Viscosity at 100 °C is 8.2 mm²/s, in the middle of the 6.9–9.3 mm²/s range for the summer grade 20.

Average values: CCS 5600 mPa·s is close to the class middle (median 5670); flash point 226 °C is close to the class middle (median 227).

Weaker values: viscosity index 163 is among the weakest in the class (median 169); pour point −42 °C is in the weaker half of the class (median −44).

Limit values: CCS 5600 mPa·s at −35 °C is 90 % of the SAE limit (6200 mPa·s); sulphated ash of 0.8 % is suitable for engines with a DPF.

Based on its values it suits engines with a DPF. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state HTHS, TBN and Noack volatility, so we cannot compare it on these parameters.