EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Castrol

Castrol GTX Ultraclean 0W-20

Castrol GTX Ultraclean 0W-20 is a 0W-20 engine oil (API SQ · ILSAC GF-7). According to the manufacturer's data sheet it has a viscosity of 44 mm²/s at 40 °C, 8.27 mm²/s at 100 °C, a viscosity index of 164, a pour point of −33 °C and sulphated ash of 0.75 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 0W-20 i
Viscosity 40 °C44 mm²/s44.145 mm²/s
Viscosity 100 °C8.27 mm²/s8.4 mm²/s
Viscosity index164 169
TBNnot stated
CCS −35 °C6000 mPa·s5670 mPa·s
Pour point−33 °C−42.5 °C
Flash point231 °C225 °C
Density0.878 g/cm³0.845 g/cm³
HTHS 150 °Cnot stated
Sulphated ash0.75 %0.79 %

All 0W-20 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Specification
API SQ · ILSAC GF-7
Oils by specification

Similar oils

Oils in the 0W-20 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 0W-20 class.

Castrol GTX Ultraclean 0W-20 is a motor oil from Castrol, viscosity grade 0W-20. In the database we compare it with 31 other oils in the 0W-20 class.

The oil meets API SQ, ILSAC GF-7, Ford WSS-M2C947-B1, Ford WSS-M2C962-A1 and more (5 in total). API SQ is the latest American specification for petrol engines, introduced in 2025. Chrysler MS-6395 is the Stellantis approval for Jeep, Dodge, RAM and Chrysler petrol engines. Ford WSS-M2C… approvals apply to specific Ford engines, check them against the owner's manual.

Viscosity at 100 °C is 8.27 mm²/s, in the middle of the 6.9–9.3 mm²/s range for the summer grade 20.

Strengths: flash point 231 °C is in the top quarter of the class (median 227).

Weaker values: viscosity index 164 is among the weakest in the class (median 169); CCS 6000 mPa·s is among the weakest in the class (median 5670); pour point −33 °C is among the weakest in the class (median −44).

Limit values: CCS 6000 mPa·s at −35 °C is 97 % of the SAE limit (6200 mPa·s), leaving little cold-start reserve; sulphated ash of 0.75 % is suitable for engines with a DPF.

Based on its values it suits engines with a DPF. The high flash point suggests low volatility and lower oil consumption. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state HTHS, TBN and Noack volatility, so we cannot compare it on these parameters.