EuropeUSA 904 oils in 35 classes + 187 American oils in 10 classes SK · EN · DE · PL · Contact
Engine oil technical data · Mobil

Mobil Delvac HDEO 10W-30

Mobil Delvac HDEO 10W-30 is a 10W-30 engine oil (10W-30). According to the manufacturer's data sheet it has 12 mm²/s at 100 °C, a viscosity index of 140, HTHS of 3.6 mPa·s, a pour point of −36 °C and sulphated ash of 1 %.

Data sheet ↗ Data verified: 19 Nov 2026

✎ Found an error? Report it

Parameters from the data sheet

ParameterValueClass median 10W-30 i
Viscosity 40 °Cnot stated
Viscosity 100 °C12 mm²/s10.9 mm²/s
Viscosity index140 148
TBNnot stated
CCS −25 °C6550 mPa·s5000 mPa·s
Pour point−36 °C−39 °C
Flash point225 °C226 °C
Density0.867 g/cm³0.865 g/cm³
HTHS 150 °C3.6 mPa·s3.4 mPa·s
Sulphated ash1 %0.995 %

All 10W-30 oils → See the class table for a detailed comparison with other oils.

Specifications and approvals

Oils by specification

Similar oils

Oils in the 10W-30 class with the closest parameters and the same specification.

Oil analysis

We wrote this text by comparing the data-sheet values with the other oils in the 10W-30 class.

Mobil Delvac HDEO 10W-30 is a motor oil from Mobil, viscosity grade 10W-30. In the database we compare it with 23 other oils in the 10W-30 class.

The oil meets Cummins CES 20081, Cummins CES 20086, Detroit DFS 93K218, Detroit DFS 93K222 and more (9 in total). Cummins CES 20086 is the Cummins approval for diesel engines, including RAM pickups. Ford WSS-M2C… approvals apply to specific Ford engines, check them against the owner's manual.

Viscosity at 100 °C is 12 mm²/s, near the upper end of the 9.3–12.5 mm²/s range for the summer grade 30. Within its class the oil is on the thick side, with more reserve at high temperatures.

Strengths: HTHS 3.6 mPa·s is in the top quarter of the class (median 3.4).

Weaker values: viscosity index 140 is among the weakest in the class (median 148); CCS 6550 mPa·s is among the weakest in the class (median 4783); pour point −36 °C is in the weaker half of the class (median −39); flash point 225 °C is in the weaker half of the class (median 227).

Limit values: HTHS 3.6 mPa·s meets the 2.9 mPa·s minimum required for this class; CCS 6550 mPa·s at −25 °C is 94 % of the SAE limit (7000 mPa·s), leaving little cold-start reserve; sulphated ash of 1 % is higher; the oil is not intended for engines with a DPF.

Based on its values it suits engines without a DPF and higher loads, towing or high-mileage engines. The specification or approval in your vehicle manual always has the final word.

The data sheet does not state TBN and Noack volatility, so we cannot compare it on these parameters.